How to solve the problem of oil stains in the production process of aluminum discs
With the innovation of technology, aluminum discs are more and more widely used in human life. It is not only in the various tableware and kitchen utensils we use, but also in the various appliances used in our lives. CD-ROM, now more aluminum discs are also applied to the body of the car, so the output of aluminum is also increasing rapidly, but some of the problems caused by the aluminum disc processing process will cause oil on the aluminum disc. The aluminum disc is not used, and the material is wasted. The following Zhongrun Aluminum will tell you how to deal with the oil pollution caused by the processing of the aluminum disc.
In the production process of aluminum discs, oil stains are prone to occur due to improper operation of equipment or personnel. In the process of cutting production and finished product inspection, the excess oil except the rolling oil film is visible to the naked eye and visible to the naked eye during the cutting production and finished product inspection.
Oil stains can cause great damage to the surface of aluminum discs. Since the finished product is used as a decorative or packaging material, it must have a clean surface. In terms of quality, oil stains refer to excessive oil on the surface of the aluminum tip after rolling.
In order to manufacture according to your own needs, the 180 degree bending angle is too much, which is greater than the minimum bending radius. Generally, the bending radius is 1.5 times the thickness of the plate. The thickness of the sheet is too thick and the bend is 180 degrees beyond the bending limit of the material.
Before the production of aluminum discs, the production equipment should be inspected. If it cannot be cleaned, it can only be disposed of as waste. In the production, oil products should be prohibited from entering the warehouse.
In short, these are just a few simple ways to solve the oil pollution problem encountered in the production process of aluminum discs, and also a solution to the problem. It is hoped that aluminum manufacturers will pay attention to some of the above factors when producing aluminum to prevent oil stains on aluminum discs.
To get more information on technology, technology, and equipment, please click on the right - line customer service. Or leave a message to us. It is our pleasure to relieve the trouble for you!
We are welcome to visit our factory at any time.
